Skip to content
Mon–Fri 8am–6pm · Sun 8am–6pm · Closed Saturdays4.9★ · 287+
(845) 262-6530
Strauss Cleaners
Technician in full protective gear spraying antimicrobial treatment on flood-cut basement walls

Rockland County, NY · ~38 min away

Mold Remediation & Removal in Nyack, NY

Sealed containment, removal of what's colonized, and a fix for the moisture behind it.

Nyack is about 38 minutes out for us. On covered mold claims we document the work and bill your insurance carrier directly, so you're not assembling the file yourself.

The Thruway makes Nyack about a 40-minute run. Downtown parking is tight and some of the older homes have steep, narrow approaches, so we plan the carry and protect the floors on the way in.

Free inspection with a written scope before any work begins. Covered claims are billed directly to your insurance carrier.

Local knowledge

What we see in Nyack

The housing stock, the terrain, and the drainage in Nyack all change how we plan a job. Here's what we run into:

Water & drainage

Everything on the slope drains through downtown to the river, and cloudbursts send sheets of runoff down the cross streets, while the waterfront rises and falls with the tide. Which side of Broadway you're on changes which water problem you get.

On the ground

Nyack fronts the tidal Hudson, and when a coastal storm lands at high tide the waterfront takes it. Sandy in 2012 damaged the marina and Memorial Park badly enough that federal repair funding topped $1.7 million. We treat waterfront lower levels as coastal exposure.

The housing stock

The Victorians climb a steep hill, so the uphill foundation wall of many homes holds back wet ground all spring. Moisture shows on that side first, and long-running damp there can look like a leak when the cause is grade and drainage.

Process

How the job goes.

Containment goes up first, the affected material comes out second, and the moisture source gets fixed before we finish. Here's the short version; the service page explains each step and why the order matters.

  1. 01

    Inspect & find the moisture

    PVC water pipes with visible mold staining on framing

    Every mold job starts as a water investigation. Moisture meters and thermal imaging trace where the water comes from: a leak, condensation, ground moisture, or a bath fan venting into the attic. Remove the mold without stopping the water and it grows back.

  2. 02

    Contain the work area

    Stone foundation wall coated white with mold-resistant encapsulant after remediation

    Plastic containment seals the affected area, and negative air machines with HEPA filtration keep airflow moving into the zone rather than out of it. Without containment, the work itself spreads spores into rooms that were clean.

  3. 03

    Remove what's colonized

    Floor-to-ceiling poly containment barrier with taped floor protection in a kitchen hallway

    Porous materials with growth (drywall, insulation, carpet) get bagged inside containment and removed; they can't be reliably cleaned. Framing and other structural wood gets HEPA-vacuumed, cleaned, and treated as its condition calls for.

  4. 04

    Clean the air & surfaces

    Poly sheeting containment wall isolating a living room while floor protection goes down

    HEPA air scrubbers run throughout, then every surface in the containment gets HEPA-vacuumed and damp-wiped. The S520 standard for finishing is a work area that is visibly clean, dust-free, and odor-free, and that's what we clean to.

  5. 05

    Fix the moisture source

    Mold-blackened, water-stained drywall exposed behind a removed bathroom vanity

    This is the repair that ends the problem: the leak fixed, the bath fan vented outside, the grading or gutter issue named in writing. We handle what's in our scope and tell you who to call for what isn't.

  6. 06

    Verify

    Mold bloom spreading across attic roof sheathing between rafters above insulation

    Final walkthrough against the written scope. If you want lab numbers behind the visual standard, we arrange third-party clearance testing, and that lab reports to you rather than to us.

The full mold remediation process, step by step →

Heavy rain in the forecast

After a storm floods the basement in Nyack: the mold clock

Storm water in a basement turns into a mold job when the drying waits. Here is what matters in the first day.

In the first day

  • Wet materials start growing mold in 24 to 48 hours. Drying fast is the mold prevention.
  • Do not run the furnace fan or box fans to dry the house. They move damp air and spores through every room.
  • If a floor drain or toilet backed up with the rain, the water is contaminated and porous materials it touched have to come out.

Full walkthrough: what to do when your basement floods in a storm. Water in the house now? Call (845) 262-6530. Same-day emergency response, six days a week.

Common problems

The problems we're usually called about.

Mold found during a home sale inspection

One line in an inspection report can hold up a closing, usually with about two weeks to deal with it. We inspect quickly, scope only what's there, do the work under containment, and provide documentation, plus third-party clearance testing if the buyer's side wants numbers.

The previous 'mold guy' sprayed and painted over it

Encapsulant sprayed over live growth on a wet wall doesn't hold, because the water is still there. We open it up, remove what should have come out the first time, dry the area and fix the moisture source, and document the work this time around.

Black mold behind a wall, under a sink, or on the ceiling

The color doesn't change the job. Black mold removal follows the same steps as any other active growth: find the moisture, contain the area, remove what's colonized, clean and dry what stays. We do the mold cleanup and the repair to the wall or ceiling afterward, under one scope.

A closet on an exterior wall grows mold every winter

A cold exterior wall, warm humid indoor air, and no circulation behind the stored boxes add up to condensation. We remediate the growth and tell you what stops it: air movement, insulation where it's missing, and humidity control. It's a small job if the cause gets addressed.

Insurance

We work with your insurance, and we bill them directly

  1. 01

    Call us

    We answer, ask what happened, and get a crew moving. Same-day emergency response on active water.

  2. 02

    We document everything

    We take moisture readings and photos and write up a scope of work before drying starts, so your adjuster has the file from day one.

  3. 03

    We bill your insurer directly

    We work directly with your insurance company on covered water and mold claims, so you're not fronting the full cost and chasing reimbursement.

Your deductible is still yours to cover. Your declarations page or your agent has the exact number, and we ask for it before any work starts rather than after. You also don't need a claim to hire us. Plenty of our jobs are paid directly by the homeowner, and after the free inspection you get a written estimate to make that decision with.

Not insurance advice. We're a restoration contractor, not a public adjuster or insurance agent. Coverage decisions belong to your insurer, so confirm anything about your policy with your agent or adjuster.

Who's showing up

Local and independent since 2019.

The person on the phone is the person planning the job. We're in Nyack every week.

  • IICRC Certified
  • Licensed
  • Bonded
  • Insured
  • Eco-Conscious Products

FAQ

Questions we get most.

Will the mold come back after remediation?

Only if the moisture comes back. Mold needs water, so fixing the leak, the drainage, the ventilation, or the humidity is what keeps it gone. That's why our remediation includes finding the moisture source and not just cleaning the visible growth. Cleaning without the repair means doing the job over again. Afterward, keep indoor humidity down, run the bath fans, and call early about new leaks.

Can I clean up mold myself?

Yes, if it's small. The EPA's rule of thumb is about 10 square feet, roughly a 3-by-3 patch. Under that, a careful homeowner can handle it with gloves, an N95 mask, and detergent, as long as the moisture source gets fixed too. Call a professional when it's bigger, inside walls or the HVAC system, involved sewage, or when someone in the house has asthma or mold sensitivity. We'll tell you at the inspection if it's a DIY-sized job.

Does homeowners insurance cover water damage?

That's a question for your insurer, and we say so on purpose. We're a restoration contractor, not a public adjuster or insurance agent, and only your carrier can tell you what your policy covers. In general terms, homeowners policies treat sudden and accidental damage, like a burst pipe or a failed water heater, differently from a slow leak that ran for months, and flooding from outside is usually a separate policy. That's why the cause of loss matters. When we inspect, we photograph and log what the damage shows, and that record goes to your insurer for their decision. Call your agent or your carrier's claim line to confirm coverage before you count on it.

Is mold in my house dangerous?

Mold can irritate eyes, nose, and throat, trigger allergic reactions like sneezing and skin rash, and aggravate asthma in people who have it. Sensitivity varies a lot from person to person. That's the EPA's position and ours. It's worth taking seriously, and it's not a reason to panic. Mold is a moisture problem in the house, and it's a fixable one.

What's the difference between mold removal and mold remediation?

"Mold removal" is a misleading term. Spores exist naturally everywhere, indoors and out, so no company can remove all mold from a house. Remediation is the accurate word: contain the affected area, take out materials too far gone, clean what can be cleaned, filter the air, and fix the moisture problem that caused the growth. Skip that last step and the mold comes back no matter how thorough the cleanup was.

Service area

Nyack, NY — Rockland County.

We're about 38 minutes out, six days a week. The homes run to Victorian and early-1900s homes stepping down the slope to the Hudson, downtown apartments over storefronts, and riverfront condos. We cover every block, including downtown Nyack, Upper Nyack, South Nyack. Nyack is known for its Victorian downtown, Memorial Park and the marina on the Hudson, and being Edward Hopper's birthplace.

Free inspection

Start with a free inspection in Nyack.

Call or send the form. We look, we measure, and you get a written scope and a straight answer. Sometimes that answer is that the work can wait.

Office hours: Mon–Fri 8am–6pm · Sun 8am–6pm · Closed Saturdays.

Free estimate

Send the details and we'll take a look.

Faster by phone? Call (845) 262-6530.